Shaved dana 60
Portal Tek is build super 14 bolts. You can get better clearence than a It had the Currie ball joint knuckles with unit bearings. Cast steel is "Dead" meaning it probably wont stress relieve when you cut the bottom of they housing off, BUT it will surely shrink when you weld the plate back on the bottom. Clockwise from the driver's top web, the numbers are: 70 You can bolt anything up but without the electronics virtually nothing would work.
Dana 60 shave kit - LetzRoll Offroad
Community Forum Software by IP. Posted 21 October - PM hell my girl told me I needed to lift mine and put bigger tires on it I'm runnin low on room in the wheel well also because of the scrub radius Due to its strength, plentiful availability, and healthy aftermarket support, the GM 14 bolt has become an extremely popular rear axle swap for off-road vehicles and custom builds, usually paired with a Dana 60 front axle. BUT, the more you shave, the more work that is involved. A plasma cutter made short work of it. Clearly it had been there for some time, and nobody was planning on coming back for it.
Nora. Age: 22. I expect you to be respectful and courteous at all times. Please before you make any quick decision look around and get to know a little more about me and if you are satisfied with all the information provide, do get in touch and we can take it from there.
spanien-urlaub-imp.info-Dana 70 Rear Axle Tech Article by BillaVista
These skid plate are or will soon be available in our web store. Yukon 35 splines in the 60 with spicer nongreasable joints and warn drive flanges. Here is a quote from my thread: instead of shaving this looks like a very viable alternitive Why would you engineer yourself into a hole? So it's basically ground clearance on the 9" but at the cost of some strength. And that is because Socrates' ideas were never made law. I contacted a welding consultant to see what rod would be best for this application.
Posted 21 October - AM. How much does the ring gear need to be turned down and do you lose any strength? Agility Customs Active Member. Posted 20 October - PM nah no portals for it Yeah don't be stupid and narrow a